DISASSEMBLY AND ASSEMBLY TRANSMISSION 3) Assemble ring washer (16) and split spacer (17) to shaft stepped portion and install snap ring (15). 4) Turn over rear housing and assemble snap ring (13) at pump mount end. Ъ Carry out the same procedure at the loader pump end. 11. Torque converter Using eyebolts, raise rear housing (11), then set to torque converter mount and tighten mounting bolts. Ъ Align the mounting bolt holes properly, and be careful of the meshing with the pump accessory gear when installing. Ъ Blow in air to check if the oil holes are correctly aligned. Mounting bolt:
112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) Ъ The length of the mounting bolts is different, so be careful when assembling. 30-62 WA250-3L