DISASSEMBLY AND ASSEMBLY TRANSMISSION 12. Rear housing 1) Using tool A1, raise rear housing (11) and assemble to front housing (44). Ъ Screw the guide pin into the front housing. (0 = 12 mm, P = 1.75, R = 55 mm) Ъ Make sure that the gasket sealant is not squeezed out inside the case. Be careful also not to coat with too much gasket sealant. Ъ See the right for details of the procedure for coating with gasket sealant. Ъ Mesh the input shaft spline correctly. Ъ Be careful not to damage the seal ring of each shaft. Mating surface of housing: Gasket sealant (Three Bond 1207B) Housing mounting bolt: 112.8 ± 4.9 Nm (11.5 ± 0.5 kgm) 2) Assemble pilot cap (10).
Ъ Remove all oil and grease from the mounting bolts and bolt holes. Cap mounting bolt: Thread tightener (LT-2) Pilot cap mounting bolt: 662.0 ± 7.4 Nm (6.75 ± 0.75 kgm) Ъ Remove tool A1 from rear housing (11). 13. 2nd and 4th shaft, tachometer pickup outlet port cover (opt.) 1) Assemble O-ring (8-1) to 2nd and 4th shaft cover (8) or (9) and install. Ъ Be careful not to let the O-ring fall out. O-ring: Transmission oil 30-63 WA250-3L