Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRANSMISSION 2) If a tachometer pick-up port is installed, mesh gear shaft and gear (9) at cover end to assemble. Ъ Coat the gear shaft with transmission oil. O-ring: Transmission oil Ъ Turn over the torque converter and transmission assembly. Ъ Set stand to the torque converter end. 14. Transmission control valve 1) Install guide bolt to mount portion of transmission control valve (7-1). Ъ Was h and remove all oil and grease from the control valve mounting bolt hole and mounting bolt thread. 2) Align with guide bolt and assemble gasket, then fit control valve (7-1) temporarily. 3) Coat mounting bolts of control valve (7-1) with thread tightener and tighten.

Ъ Tighten the mounting bolts in turn on diametrically opposite sides and be careful not to tighten too far. Ъ The length of the mounting bolts is different, so be careful when using them. Ъ The lengths are as follows. R = 120 mm ˇ R = 130 mm R = 135 mm С R = 115 mm Т R = 100 mm Mounting bolt: Thread tightener (LT-2) Mounting bolt: 34.3 ± 4.9 Nm (3.5 ± 0.5 kgm) 30-64 WA250-3L