Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRANSMISSION 17. Hydraulic piping Connect following hydraulic piping. ! Hose (1) between torque converter oil filter and transmission valve ! Hose (2) between torque converter charging pump and torque converter oil filter ! Connect hose and tube (3) between strainer and charging pump. ! Connect PTO lubrication tube (4). Ъ Be careful not to crush the tube during the operation. 18. Adjusting speedometer sensor 1) Screw in sensor (54) until it contacts outermost surface of gear (55). Ъ Before installing the sensor, check that the gear is at the outermost circumference in relation to the mounting surface.

Ъ When screwing in the sensor with a wrench, stop before it contacts the gear, and finally tighten by hand until it is lightly in contact. 2) After sensor (54) contacts gear (55), turn it back 1/2 - 1 turn, and secure it in position with locknut (56). Ъ When securing with the locknut, hold the other nut with a wrench when tightening. Sensor thread portion: Gasket sealant (LG-5) Sensor lock nut: 58.8 ± 9.8 Nm (6 ± 1 kgm) Ъ Install the transmission bracket. 30-66 WA250-3L