DISASSEMBLY AND ASSEMBLY TRANSMISSION 4. Clutch plate Remove plate (9), disc (10), and spring (11) from housing. 5. Piston Blow air in FORWARD oil hole of shaft and remove piston (12). Ъ If the piston is at an angle and cannot be removed, push the piston in and try to remove it again. Ъ Do not use force to remove it. The inside circumference of the cylinder will be damaged. 6. Bearing Ъ Set on tool B1 with the REVERSE clutch side at the top. Using puller, remove gear (13) and bearing (14). 7. REVERSE gear Remove spacer (15), thrust washer (16), needle bearing (17), REVERSE gear (13), thrust washer(19). Ъ Repeat Steps 3 - 5 for the FORWARD clutch to disassemble the other parts. 8.
Shaft, cylinder 1) Remove snap ring (75) from shaft and housing, then remove housing (77). 2) Remove snap ring (75-1), then remove housing (77). 30-68 WA250-3L