Komatsu — DISASSEMBLY OF 1ST AND 3RD CLUTCH PACK

DISASSEMBLY AND ASSEMBLY TRANSMISSION Disassembly of 1st and 3rd clutch pack Ъ Set on tool B1 with the 1st clutch side at the top. 1. Idler gear 1) Using puller, pull out bearing (21) and remove spacer (22). 2) Remove snap ring (22-1), then remove idler gear (20). 2. 1st gear Remove thrust washer (23), needle bearing (25),1st gear (34), needle bearing (25-1), and thrust washer (23-1). 3. End plate 1) Install tools B3 and B5 and tighten tool B4, then remove ring (26). Ъ When removing the ring, remove tool B3. 2) Remove end plate (27). 30-69 WA250-3L