Komatsu — DISASSEMBLY OF 1ST AND 3RD CLUTCH PACK

DISASSEMBLY AND ASSEMBLY TRANSMISSION 4. Clutch plate 1) Remove plate (28), disc (29), and spring (30) from housing. 2) Remove thrust washer (31). 5. Piston Blow air in REVERSE oil hole of shaft, and remove piston (32). Ъ If the piston is at an angle and cannot be removed, push the piston in and try to remove it again. Ъ Do not use force to remove it. The inside circumference of the cylinder will be damaged. 6. Bearing Ъ Set on tool B1 with the 3rd clutch side at the top. Using puller, remove bearing (33). 7. 3rd gear Remove spacer (34), thrust washer (35), needle bearing (36), 3rd gear (37), and thrust washer (38).

Ъ Use the same procedure as in Steps 3 - 5 for the 1st gear to continue disassembly. 30-70 WA250-3L