DISASSEMBLY AND ASSEMBLY TRANSMISSION 4. Clutch plate Remove plate (46), disc (47), and spring (48) from housing. 5. Piston Blow air in 4th oil hole of shaft, and remove piston (49). Ъ If the piston is at an angle and cannot be removed, push the piston in and try to remove it again. Ъ Do not use force to remove it. The inside circumference of the cylinder will be damaged. 6. Idler gear Ъ Set on tool B1 with the 2nd clutch side at the top. 1) Using puller, pull out bearing (51) and remove snap ring (50- 1). Ъ When fitting the puller, put the plate in contact with the center first. 2) After removing the snap ring, remove idler gear (50). 7.
2nd gear Remove thrust washer (52), needle bearing (53), 2nd gear (54), and thrust washer (55). Use the same procedure as in Steps 3 - 5 for the 2nd gear to continue disassembly. 30-72 WA250-3L