DISASSEMBLY AND ASSEMBLY TRANSMISSION ASSEMBLY Assembly of FORWARD, REVERSE clutch pack WARNING! The clutch pack is oily, so be careful not to let it slip when setting the clutch pack on the stand. Be careful also not to get your fingers caught between the stand and the clutch pack. 1. Housing Assemble snap ring (75-1) to one side of housing (77). 2. Shaft, housing 1) Assemble snap ring (57-1) to housing, then set on tool B1. 2) Assemble shaft and housing to housing (77)and install snap ring (75). 3. Piston seal Assemble piston seal (56-1) to piston (56). Ъ When assembling a new piston seal, use tool B6 to make the seal fit well (time:approx. 2 - 3 minutes), then assemble the seal.
Ъ If the seal is assembled to the cylinder without making it fit first, the seal will be damaged. Inside surface of tool B6: Transmission oil 4. REVERSE piston Install REVERSE piston (56). Ъ Be careful not to damage the piston seal. Ъ Check that the spring pin does not extend from the circumference of the shaft. Sliding surface of piston seal: Transmission oil 5. Clutch plate Insert tool B2 in housing and assemble plate (57) disc (58), and spring (59) in turn. Ъ Soak disc (58) in clean transmission oil for at least 2 minutes before assembling. Ъ Be careful to assemble so that disc (58) and spring (59) are not resting on each other.
Ъ Be careful that the plate or spring are not caught in the clutch housing ring groove when assembling. 30-73 WA250-3L