Komatsu — ASSEMBLY OF FORWARD, REVERSE CLUTCH PACK

DISASSEMBLY AND ASSEMBLY TRANSMISSION 6. End plate 1) Install tools B3 and B5, then tighten tool B4 to push in end plate (60). 2) Assemble ring (61) and remove tool B3. Ъ Check that the disc rotates smoothly by hand. 7. Thrust washer Install thrust washer (19). 8. REVERSE gear Align spline groove on inside of plate with a screwdriver to assemble gear (13). Ъ If the gear spline does not match, turn lightly when assembling. Never use force to push it in. 9. Needle bearing Assemble needle bearing (17) and thrust washer (16). Ъ Check that the end face of the thrust washer is below the surface of the stepped portion of the shaft. 10 Bearing Assemble spacer (15) and press fit bearing (14).

Ъ Press fit completely so that spacer (15) is in tight contact with bearing (14) at the stepped portion of the shaft. Ъ After press fitting the bearing, check that the clearance between the thrust washer and spacer is within the specified range. a = 0.1 = 0.9 mm 11. REVERSE piston 1) Turn over clutch pack. WARNING! When turning over the clutch pack, be careful 30-74 WA250-3L