DISASSEMBLY AND ASSEMBLY TRANSMISSION 12. 4th gear 1) Assemble 4th gear (42) and needle bearing (43). Ъ Assemble in the same way as for the 2nd gear. Ъ Assemble the bottom needle bearing first. 2) Assemble top needle bearing (43-1). 3) Assemble thrust washer (41-1). Ъ Check that the end face of the thrust washer is below the surface of the stepped portion of the shaft. 13. Bearing Assemble idler gear (39) and press fit bearing (40). Ъ Press fit completely so that the spacer is in tight contact with bearing (40) at the stepped portion of the shaft. Ъ After press fitting the bearing, check that the clearance "f" between the thrust bearing and spacer is within the specified range.
Ъ f = 0.07 - 1.33 mm 14. Clutch pack operation test Blow in compressed air through oil hole in shaft and check that each clutch works properly. Ъ If the gear where the air is blown in is held in position, the clutch is working properly. 30-84 WA250-3L