DISASSEMBLY AND ASSEMBLY PARKING BRAKE ASSEMBLY ASSEMBLY 1. Housing 1) Press fit oil seal (22) and dust seal (23) to housing (4). Ъ Be careful not to let the seal lean at an angle when press fitting. Ъ Oil seal press-fitting dimension (a): 19 ± 1 mm Ъ Dust seal press-fitting dimension (b): 11 ± 1 mm Lip of seal: Grease (G2-L1) Ъ Coat with grease when assembling the housing. 2) Press fit needle bearing (24) and oil seal (25) to housing (4) to specified dimension. Ъ Needle bearing press-fitting dimension (c) : 39.0 ± 0.1 mm (1st) Ъ Needle bearing press-fitting dimension (d): 17.0 ± 0.5 mm (2nd) Ъ Oil seal press-fitting dimension (e): 8.0 ± 0.3 mm Lip of seal:
Grease (G2-L1) Ъ Set a stand under the housing to prevent the bearing and seal from leaning at an angle when press fitting. 3) Insert outside lever (19) from oil seal end. Ъ Clean and remove all oil and grease from the bolt hole of the outside lever. 4) Align match marks and assemble inside lever (18) 5) Coat thread of lock bolt (17) with thread tightener, then tighten. Lock bolt: Thread tightener (LT-2) Lock bolt: 66.2 ± 7.4 Nm (6.75 ± 0.75 kgm) Ъ Do not forget to assemble the washer. Ъ Clean and remove all oil and grease from the lock bolt and bolt hole. 30-87 WA250-3L