DISASSEMBLY AND ASSEMBLY PARKING BRAKE ASSEMBLY 2) Set retainer assembly on tool C1 then set spacer on top of separator plate (7), install tools C2, C3, and C4 and tighten C3, and assemble ring (8). Ъ Use the same spacer that was used during disassembly. Ъ After assembling the ring, remove tools C2, C3, C4, and the spacer. Ъ Check that the disc rotates smoothly by hand. 5. Hub spline Align with spline and assemble hub spline (6). Ъ If the hub spline cannot be aligned, rotate it lightly when assembling. Do not use force to push it in. 6. Brake housing and retainer 1) Assemble gasket seat to join of retainer (1), then install housing (4).
Ъ Wipe the mating surface of the retainer and housing clean before assembling. Ъ Do not remove the two set bolts (49) for holding the piston which were installed when removing parking brake assembly (1). Replace them with a plug after assembly. 2) Tighten mounting bolts (2) uniformly on diagonally opposite sides. Mounting bolt: 110.3 ± 12.3 Nm (11.25 ± 1.25 kgm) 30-89 WA250-3L