DISASSEMBLY AND ASSEMBLY DIFFERENTIAL 5) Assemble bevel gear (10) in differential carrier (12), then tighten mounting bolts. Mounting bolts: Adhesive (LT-2) Mounting bolts: 279.5 ± 29.4 Nm (28.5 ± 3.O kgm) Ъ The bevel gears for the front axle and rear axle are different, so be careful not to mistake them when assembling. Ъ Coat the thrust washer with grease and stick it to the bevel gear to prevent it from failing off during installation. Ъ Align the lock of the washer correctly with the groove in the bevel gear. 4. Adjusting shim of cage 1) Assemble cage (5) without shims in differential housing (8). Mounting bolts:
112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) 2) Insert measuring tool D1 in differential housing (8), and measuring distance between end face of bevel pinion gear and tool D1 with an inside micrometer or a cylinder gauge. Ъ When inserting tool D1 in the differential housing, coat thinly with oil and insert straight without twisting. 3) Selecting shim t = C - (L + D/2) t : Shim thickness C: (A + a) - (B + b) L : Measured value D : Diameter of tool D1 A : 167.8 B : 50.5 a : Deviation for dimension A b : Deviation for dimension B Ъ Use the measured value for distance D Ъ Shim thickness "t" must be within 0.5 - 1.9 mm The end of the pinion gear is marked with an electric pen as follows. Example:
MD combination No. for bevel pinion gear and bevel gear +0.10 Distance "a" (mm) (-0.01) Distance "b" (mm) 4) Remove cage. 30-119 WA250-3L