DISASSEMBLY AND ASSEMBLY DIFFERENTIAL 5. Bearing carrier Press fit bearing cups (32) and (33) in bearing carriers (7) and (31). Press-fitting portion of bearing cup: Oil (axle oil) 6. Adjusting bearing carrier shims 1) Raise differential carrier assembly (9), set in mounting position, then install left and right bearing carriers (7) temporarily. Ъ Assemble the differential carrier assembly with the bevel gear on the right as seen from the cage mount. Ъ Assemble the bearing carrier and adjust without the angle ring and shim. 2) Tighten carrier (31) at differential carrier end to specified tightening torque. Mounting bolts:
112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) 3) Tighten 4 mounting bolts of carrier (7) at bevel gear end. Ъ Rotate the bevel gear and coat the bearing with oil. Bearing: Oil (axle oil) Ъ To settle all the parts, rotate the bevel gear when tightening. Mounting bolts: 11.8 Nm (1.2 kgm) 30-120 WA250-3L