Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY CENTER HINGE PIN CENTER HINGE PIN INSTALLATION Carry out installation in the reverse order of removal. Ъ Align the pilot portion securely and take care to assemble with the coupling facing in the correct direction. Mounting bolt 66.2 ± 7.4 nM (6.75 ± 0.75 KGM) Ъ After connecting the drive shaft, remove the block. Ъ If the operation of the brake is poor, carry out adjustment. For details, see TESTING AND ADJUSTING. Hose mouthpiece nut (16 mm): 13.2 ± 1.5 Nm (1.35 ± 0.15 kgm) Hose mouthpiece nut (24 mm): 31.9 ± 2.5 Nm (3.25 ± 0.25 kgm) Ъ For details of the adjustment of the cable length, see TESTING AND ADJUSTING. Cable joint nut:

13.7 ± 1 Nm (1.4 ± 0.1 kgm) Ъ For details of adjusting the work equipment lever, see TESTING AND ADJUSTING. Ъ Fit the lock of the connector securely. Mounting bolt: 279.5 ± 29.4 Nm (28.5 ± 3.0 kgm) Ъ Adjust shims so that the total clearance is within the standard value. Ъ Clearance: Max. 0.5 mm Outside circumference of hinge pin: Grease (G2-LI) WARNING! When aligning the position of the pin hole, use a bar. Never insert your fingers in the pin hole. Ъ Be extremely careful when adjusting the height, and set so that the pin can be inserted easily by hand. 30-144 WA250-3L