DISASSEMBLY AND ASSEMBLY CENTER HINGE PIN Ъ Tighten washer (49) and lockout (50) to the specified torque, then select shim so that the clearance a between the rear frame and pin is the specified value. Ъ When tightening the lockout, tighten the mounting bolt temporarily to prevent turning. Clearance a: Max. 0.1 mm Ъ Standard shim thickness: 1.45 mm Lockout: 568.8 ± 58.8 Nm (58.0 ± 6.0 kg) (width across flats: 55 mm) Ъ Assemble the selected shim, and tighten the pin mounting bolts. Ъ Before tightening the mounting bolts, tighten the lockout to the specified torque again. Lockout: 568.8 ± 58.8 Nm (58.0 ± 6.0 kgm) Mounting bolt: 112.8 ± 9.8 Nm (11.5 ± 1.0 kgm) WARNING !
When aligning the position of the pin hole, use a bar. Never insert your fingers in the pin hole. Ъ When joining, be careful not to get the spacer at the bottom of the upper hinge caught. Ъ Align the pin holes securely. Ъ Install the safety bar. Ъ Be careful not to damage the seal lip, and assemble with the lip on the outside. Lip of seal: Grease (G2-L1) Inside circumference of spacer: Grease (G2-L1) 1) Tighten the retainer with 3 bolts. Mounting bolt: 14.7 ± 1.5 Nm (1.5 ± 0.15 kgm) (when adjusting shim) 2) Measure the clearance between the retainer and hinge, then select shims and assemble so that the maximum clearance is less than 0.1 mm. Ъ Clearance b: Max.
0.1 mm Ъ Standard shim thickness: 0.85 mm 3) After assembling the shim, tighten 6 bolts. Mounting bolt: 66.2 ± 7.3 Nm (6.75 ± 0.75 kgm) 30-145 WA250-3L