Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY CENTER HINGE PIN Ъ When press fitting the dust seal, be careful that the lip is on the outside. Lip of seal: Grease (G2-L1) Ъ The clearance between the bearing and spacer is adjusted, so do not change the combination. When replacing, always replace the parts as a set. Ъ When press fitting the bearing, press fit securely so that there is no clearance from the contact surface of the frame. Bearing: Grease (G2-L1) 1) Tighten the retainer with 3 bolts. Mounting bolt: 14.7 ± 1.5 Nm (1.5± 0.15 kg) (when adjusting shim) 2) Measure the clearance between the retainer and hinge, then select shims and assemble so that the maximum clearance is less than 0.1 mm. Ъ Clearance c:

Max. 0.1 mm Ъ Standard shim thickness: 0.92 mm 3) After assembling the shim, tighten 6 bolts. Mounting bolt: 66.2 ± 7.3 Nm (6.75 ± 0.75 kgm) Ъ When press fitting the dust seal, be careful that the lip is on the outside. Lip of seal: Grease (G2-L1) Ъ The clearance between the bearing and spacer is adjusted, so do not change the combination. Ъ When press fitting the bearing, press fit securely so that there is no clearance from the contact surface of the frame. Bearing: Grease (G2-L1) 30-146 WA250-3L