DISASSEMBLY AND ASSEMBLY STEERING VALVE STEERING VALVE DISASSEMBLY Ъ Use a wire brush to remove all the dirt and dust stuck to the joint around the outside circumference of the unit. Ъ Carry out the operation in a clean place to prevent dirt or dust from sticking to the valve. Ъ As long as possible, hold the valve in a vice when disassembling. DISASSEMBLY OF ROTOR 1. Set rotor side facing up, and hold mounting flange lightly in vice в . Ъ Put a copper plate in contact with the vice and be careful not to tighten the vice too hard. 2. Remove screw (1), then remove end cap (2). 3. Remove O-ring (3) from end cap (2). 4. Pull out rotor set (4), then remove O-ring (5).
Ъ Be careful not to drop the star inside the rotor set. 5. Remove spacer (6). 30-151 WA250-3L