DISASSEMBLY AND ASSEMBLY WORK EQUIPMENT WORK EQUIPMENT REMOVAL WARNING! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. 1. Bucket link 1) Remove bucket link mounting pin (1). Ъ Secure the bucket link to the bellcrank with wire. 2) Remove bucket hinge mounting pin (2). WARNING! Never insert your fingers in the pin hole. 3) Move machine towards rear and disconnect bucket. 2. Bucket cylinder mounting pin Sling bucket cylinder (3), then pull out pin (4) and disconnect cylinder rod and belicrank.
Ъ Set block в between the cylinder bottom and frame. Bucket cylinder: 80 kg 3. Boom cylinder pin Sling boom cylinder (5), and remove mounting pin (6). Ъ Set stand Є under the tip of the boom. Ъ Release the pressure in the hydraulic piping. Ъ Set a block on the top of the axle, then lower the cylinder. Boom cylinder: 87 kg 30-190 WA250-3L