MAINTENANCE STANDARD TRANSMISSION FORWARD, REVERSE CLUTCH Unit: mm 40-12 No.
Check item Criteria Remedy 1 Clearance between piston and cylinder (FORWARD, REVERSE) Standard size Tolerance Standard clearance Clearance limit Replace Shaft Hole Inside 110 -0.27 -0.32 +0.06 -0.07 0.20 - 0.38 0.43 Outside 137.5 -0.2 -0.25 +0.13 0 0.20 - 0.38 0.43 2 Clearance (R) at bearing press-fitting portion of FORWARD, REVERSE clutch shaft 50 +0.025 +0.009 0 -0.012 -0.009 - -0.037 - 3 Clearance (F) at bearing press-fitting portion of FORWARD, REVERSE clutch shaft 50 +0.025 +0.009 0 -0.012 -0.009 - -0.037 - 4 Thickness of separator plate Standard size Tolerance Repair limit 1.7 ± 0.05 1.6 Distortion of separator plate - 0.1 0.15 5 Thickness of friction plate 2.2 ± 0.08 1.9 Distortion of friction plate - 0.1 0.25 6 Load of wave spring (at height:
2.2 mm) 100.1 N (103 kg) ± 10.1 N ( ± 10.3 kg) 804 N (82 kg) 7 End play of FORWARD gear 0.07 - 1.33 8 End play of REVERSE gear 0.1 - 0.9 9 Clearance (R) at spacer press-fitting portion of FORWARD, REVERSE clutch shaft Standard size Tolerance Standard clearance Clearance limit Shaft Hole 51 +0.025 +0.009 0 -0.03 -0.009 - -0.055 - Clearance (F) at spacer press-fitting portion of FORWARD, REVERSE clutch shaft 51 +0.025 +0.009 0 -0.03 -0.009 - -0.055 - 10 Thickness of FORWARD, REVERSE clutch thrust washer Standard size Tolerance Repair limit 11 Thickness of FORWARD, REVERSE clutch spacer 3.0 ± 0.1 2.7 5.0 ± 0.05 -