Komatsu — TRANSMISSION

MAINTENANCE STANDARD TRANSMISSION 1ST, 3RD CLUTCH Unit: mm 40-13 No.

Check item Criteria Remedy 1 Clearance between piston and cylinder Standard size Tolerance Standard clearance Clearance limit Replace Shaft Hole Inside 110 -0.27 -0.32 +0.06 -0.07 0.20 - 0.38 0.43 Outside 165 -0.27 -0.32 +0.06 -0.07 0.20 - 0.38 0.43 2 Clearance (R) at bearing press-fitting portion of 1st, 3rd clutch shaft 55 +0.030 +0.011 0 -0.015 -0.011 - -0.045 - 3 Clearance (F) at bearing press-fitting portion of 1st, 3rd clutch shaft 45 +0.025 +0.009 0 -0.012 -0.009 - -0.037 - 4 End play of 1st gear 1.00 - 1.59 5 End play of 3rd gear 0.1 - 0.9 6 Clearance (R) at spacer press-fitting portion of 1st, 3rd clutch shaft Standard size Tolerance Standard clearance Clearance limit Shaft Hole 56 +0.030 +0.011 0 -0.030 -0.011 - -0.060 - 7 Clearance (F) at spacer press-fitting portion of 1st, 3rd clutch shaft 55 +0.025 -0.015 +0.090 - +0.015 -0.010 - +0.105 - 8 Thickness of gear end face clutch thrust washer Standard size Tolerance Repair limit 3.0 ± 0.1 2.7 9 Thickness of clutch thrust washer 3.0 ± 0.1 2.7 10 Thickness of 3rd clutch spacer 5.0 ± 0.05 -