Inspection 1. General Inspection Check the following and repair or replace parts if faulty. (1) Check fuel passages (jets) and air passages (jets or orifices) for clogging. If clogged, wash thoroughly with cleaning solvent or detergent and remove dirt by compressed air. Do not use wire or other metal pieces. (2) Check diaphragms, O-rings and springs for damage and cracks. (3) Check that needle valve operates lightly. If the valve is hard to operate or is binding, repair or replace. If there is overflow, poor valve to seat contact is suspected. Check thoroughly. (4) Check the fuel inlet filter (located above the needle valve) for clogging and damage. (5) Check the float operation.
Check float and lever for deformation and damage and replace if necessary. (6) Check operation of the throttle valve, choke valve and link. If they do not operate lightly, wash well and apply engine oil sparelingly to their shaft. (7) Check the float chamber cover and main body for damage and cracks. 2. Fuel Cut Solenoid Valve Operation Check (1) Connect the battery directly to the body and terminal of the fuel cut solenoid valve to apply the voltage. Caution: Use care not to short-circuit the battery. 12V (2) Listen to a click which should be heard when the valve operates normally at the moment the battery is connected. 6EN0853 3.
Fuel Cut Solenoid Valve Resistance Check Measure the resistance between the body and the terminal of the fuel cut solenoid valve with a tester. Standard value: Approx. 90 Ω [at 20°C (68°F)] 6EN0854 G424 Service Manual Gasoline Fuel System 68