daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

4. Inspection of Mixture Adjusting Screw (MAS) Check tapered end of mixture adjusting screw (MAS) for damage from over tightening, etc. Check for damage 6EN1888 5. Throttle Body Check Make sure that the throttle shaft moves smoothly. If any sticky movement is found, thoroughly clean the shaft, and then coat it with a small amount of engine oil. Do not disassemble the shaft unnecessarily. 6EN0855 Service Points of Reassembly For reassembly, reverse the order of disassembly while paying much attention to the following: (1) Clean every parts with clear cleaning oil before reassembly. Check all passages for clogging. (2) Replace all the removed packings and gaskets.

(3) Make sure the throttle and choke linkage operates smoothly. If any sticky movement is found, clean or replace the linkage, and make sure that the carburetor operates without any problem. A Installation of main jets Main jet (1) When replacing a main jet, the oil jet and the new jet must be of the same size, because the jet is selected after exact flow measurement by factory. (A size symbol is stamped on each jet.) 6EN0852 G424 Service Manual Gasoline Fuel System 69