. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING for the repairs. 4 - 79 EVERY 2000 HOUR Maintenance for every 100, 250, 500 and 1000 hours should be carried ou t at the same tim The component parts an d oil are warmed up to high temperature just af ter an opera tion. A casual touch willcause a burn. Henc start the replacement jo b after the temperature cools do wn. If pressure is still left in the case, oil may spurt out, or th e plug may f ly off. Relea se the i nternal resi dual pressur e by turnin the plug slowly.
A container of capac ity over 9.5 liters (2.51 US gal ) to receive drained oi Replacement amoun t oil 9.5 liters (2.51 US gal) on right and l Prepare a handle. 1. Set the TOP mark at the top, with the TOP mark and plug (P perpendicular to the ground surface. 2. Place an oil receiving container under plug (P). 3. Remove plugs (P) and (F), using a handle, to drain oil. REMARK Check an O-ring fitted to the plug for any damage, and replace with new one, if judged necessary. 4. Tighten plug (P). 5. Add engine oil through the hole of plug (F). 6. When oil begins to overflow from the plug (F) hole, install plu (F). Tightening torque of plugs (P) and (F):
68.6 ± 9.8 N·m (7 ± 1 kgf·m, 50.6 ± 7.2 lbft) 1. Set the TOP mark a t the top, with the TOP mark and plug (P 2. Place an oil receivin 3. Remove plugs (P) a nd (F), using a handle, to dra in oil. 5. Add engine oil throu 6. When oil begins to overflow from the plug (F) hol e, install plu CHECK ALTERNATOR, Wear on the brush and the bearings short of grease a re suspect ed, so ask the Komatsu dist ributor in yo ur territor NOTICE If the engine is started freq uently, shorten the periodic chec k interval to every 1000 hours o f operation. CHECK ENGINE VALVE As special tool is requir ed for removing and adjusting the parts, you shall r equest Komatsu distributor f or service