OPERATING THE BRAKE SYSTEM Steering Angle Sensor Re-Calibration ATC Functions (standard) For vehicles equipped with ESC "Electronic Stability Control" do not replace the vehicle’s steering wheel with an aftermarket or different part number than originally supplied. Us- ing a different steering wheel could cause ESC to malfunction causing a loss of vehicle control possibly resulting in an accident involving death or personal injury. WARNING!
Whenever maintenance or repair work is performed to the steering mechanism, linkage, gear, adjustment of the wheel track, or if the steering angle sensor is replaced or the steering wheel is changed or re-centered, the Steering Angle Sensor must be re-calibrated. Your truck/tractor ABS may be equipped with an automatic traction control (ATC) feature. This feature is controlled by a switch as shown in the next illustration. This feature is monitored by a warning lamp located on the switch. 4 WARNING! If the Steering Angle Sensor is not re-calibrated, the Yaw Control sys- tem will not function properly.
A un- calibrated sensor could result in a loss of control of your vehicle which can lead to an accident involving death or personal injury. Automatic Traction Control Warning Lamp The Traction Control warning lamp on page 3-20 will briefly illuminate and then go out when the ignition switch is first turned on. The traction control warning lamp will illuminate whenever the ATC system detects drive wheel spin. The lamp will remain illuminated as long as wheel spin is detected and the ATC system is applying the 4-32 Y53-6060-1C1 (03/17)