TROUBLESHOOTING / Troubleshooting A Shorted circuit in CAN harness between power circuit and CAN circuit. YES Shorted circuit in CAN harness between key signal circuit and CAN circuit. YES · Key switch: OFF · Refer to “Discontinuity Check between CAN Circuit and Key Signal Circuit” on T5-6-69 to 71. YES Shorted circuit in CAN harness. YES To A · Key switch: OFF · Refer to “Discontinuity Check in CAN Harness” on T5-6-72-to 73. To B Connector · Key switch: OFF MC Connector MC-C (Harness end) · Key switch:
OFF #C15 #C4 C23 C31 Monitor Unit Connector Monitor-B (Harness end) #18 #37 T1GR-05-04-002 T5-6-82 Check for continuity etween key signal ircuit (MC, ICF, NO ECM, monitor unit) nd CAN circuit. Check for continuity between High side and Low side in CAN NO harness. Connect all connectors except connector MC-C in MC. Check if resistance NO between terminals #C4 and #C5 of harness end of connector MC-C is within 60±10 Ω. Disconnect connector in ECM. Connect MC-C connector in MC. Check if resistance NO between terminals #18 and #37 of harness end of connector in ECM is within 120±10 Ω. C1 C10