hitachi — PREPARATION FOR PERFORMANCE TESTS

TROUBLESHOOTING / Troubleshooting B T5-7-9 Solenoid Valve Unit (SC) Pump 1 Control Solenoid Valve Pump 2 Control Solenoid Valve • Controls boom mode selector control. Reduces boom overload relief pressure to 11.8 MPa (120 kgf/cm2) at 110 L/min. • Changes pump 1 swash angle. • Changes pump 2 swash angle. • Boom overload relief pressure is not re- duced. • Pump control is inoperable. • Pump control is inoperable. • Even if boom mode selector switch is turned ON, boom lower power and vibra- tion cannot be controlled. • If harness is disconnected and solenoid valve is faulty, flow rate of pump 1 be- comes minimum.

• If harness is disconnected and solenoid valve is faulty, flow rate of pump 2 be- comes minimum. Fault code 11989 is displayed. Fault code 11410 is displayed. Fault code 11400 is displayed. Monitor Item: Boom Mode Control Valve Output Monitor Item: Pump 1 Proportional Solenoid Valve Current Monitor Item: Pump 2 Proportional Solenoid Valve Current • Install lamp harness (ST 7130). Check output signals from MC and harness condition. - - - - - - • Judge if solenoid valve is broken or har- ness is disconnected by switching with another solenoid valve harness.

(Switch harness of delivery pressure sensor and regulator pressure sensor.) • Judge if solenoid valve is broken or har- ness is disconnected by switching with another solenoid valve harness. (Switch harness of delivery pressure sensor and regulator pressure sensor.) T2-1 T2-1 T2-1