TROUBLESHOOTING / Troubleshooting B T5-7-14 Parts Learning Switch Flow Combiner Valve Boom Overload Relief Control Valve Function • Starts pump learning ON: 0 V → Learning OFF: 5 V → Normal control • Supplies oil to both right and left travel spools from pump 1 during combined operation of travel and front/swing. • Reduces pressure in boom lower circuit. Symptoms in control system when trouble oc- curs. • Pump learning is not per- formed. • During combined operation of travel and front/swing, oil is not supplied to left travel spool, or insufficient oil is supplied to left travel spool.
• If valve is bound at fully closed, when boom lower is operated with boom mode selector switch ON, machine can be raised off ground with front attachment. • If spool is bound at fully open, when boom lower is operated with boom mode selector switch OFF, machine cannot be raised off ground with front attachment. (Power is weak.) Symptoms in machine operation when trouble occurs. • If problem is caused by open circuit or discontinuity of switch, machine operates normally. (Only learning can- not be performed.) • If shorted circuit occurs, learning mode operation starts when key switch is turned ON. Therefore, engine will stall at 2 second or 20 seconds after engine starts.
• While traveling, when front/swing lever is operated, machine mistracks to the left. • If valve is bound at fully closed, when boom lower is operated with boom mode selector switch ON, machine can be raised off ground with front attachment. • If spool is bound at fully open, when boom lower is operated with boom mode selector switch OFF, machine cannot be raised off ground with front attachment. (Power is weak.) Evaluation By MC Fault Code - - - By Monitor Function Monitor Item: Pump 1 Regulator Pressure Learning Status, Pump 2 Regulator Pressure Learning Status - - Using Test Harness - - - Others - - - NOTE - - - Descriptions of Control (Operational Principle Section in T/M) T2-1 T3-3 T3-3