TROUBLESHOOTING / Troubleshooting B Even if the power mode switch is not turned to HP mode, HP mode is operable. Reference Page T5-6-28 Boom raise and arm roll-in must be operated when the average delivery pressures of pump 1 and 2 are high, if HP mode control is performed. The sensors related to this condition may not be faulty at the same time. YES Shorted circuit in harness between MC and power mode switch. Monitor the power mode switch. Check if “ON” is dis- played. YES Faulty ECM. · Monitor item: HP mode switch · Power mode switch: P mode NO Check if fault code 11004-2 is displayed. NO Faulty MC. T5-7-43 Trouble 11004 CAN Communication Error