hitachi — PREPARATION FOR PERFORMANCE TESTS

TROUBLESHOOTING / Troubleshooting B Even if power mode switch is not turned to E mode, engine speed decreases. Reference Page T5-6-28 Required engine speed from the engine control dial must be beyond 1580 min -1 when the pump control pressures of pump 1 and 2 are low or the average delivery pressures of pump 1 and 2 are high, if E mode control is performed. The sensors related to this condition may not be faulty at the same time. T5-7-45 Trouble 11004 CAN Communication Error Shorted circuit in harness NO between MC and power mode switch, or faulty power mode switch. Monitor power mode switch. Check if “E” is displayed. YES Refer to Fault Code 11004 in Troubleshooting A. · Monitor item:

EP mode switch · Power mode switch: P mode Check if fault code YES 11004-2 is displayed. Faulty MC. NO Shorted circuit in harness between MC and power mode switch, or faulty power mode switch. Faulty MC. NO Monitor power mode switch. Check if “E” is displayed.