OPERATIONAL PERFORMANCE TEST / Excavator Test TRAVEL MOTOR LEAKAGE Summary: To measure the parking brake function on a specified slope. Preparation: 1. The surface of the test slope shall be even with a gradient of 20 % (11.31 ° ). 2. Hold the bucket 0.2 to 0.3 m (8 to 12 in) above the ground with the arm and bucket fully rolled in. IMPORTANT: The bucket teeth will hit the boom if the bucket is rolled-in with the arm fully rolled-in. As for this condition: arm fully rolled-in + Bucket fully rolled-in, set the bucket at fully rolled-in and a perform arm roll-in operation. 3. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Measurement: 1.
Measure the travel parking brake slip amount while parked. 2. Climb the slope and place the travel levers in neutral. 3. Stop the engine. 4. After the machine stops, put the matching marks on a track link or shoe, and the track side frame. 5. After 5 minutes, measure the distance between the marks on the track link or shoe and the track side frame. Evaluation: Refer to the Performance Standard Table in Group T4-2. 0.2 to 0.3 m T105-06-03-004 T105-06-03-006 T4-4-4 Alignment m and shoe wh Displacemen Alignment m and shoe wh arks on the track side frame en the machine comes to a stop. Displacemen t measured after 5 minutes.