OPERATIONAL PERFORMANCE TEST / Excavator Test SWING FUNCTION DRIFT CHECK Summary: Measure the swing drift on the bearing outer cir- cumference when stopping after a 180 ° full-speed swing. Preparation: 1. Check the lubrication of the swing gear and swing bearing. 2. Place the machine on flat, solid ground with am- ple space for swinging. Do not conduct this test on a slope. 3. With the bucket empty, position the front attach- ment as follows: Backhoe: With the arm cylinder fully retracted, and the bucket cylinder fully extended, raise the boom so that the arm tip pin height is flush with the boom foot pin height. Loading shovel:
With the arm cylinder and the bucket cylinder fully extended, raise the boom so that the arm tip pin height is flush with the boom foot pin height. 4. Put the matching marks on the swing bearing and on the track frame by using a tape, as illus- trated. 5. Swing the upperstructure 180 ° . 6. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Two Matching Marks T105-06-03-008 T105-06-03-009 Measure Difference Between Marks CAUTION: Prevent personal injury. Always make sure that the area is clear and that co-workers are out of the swing area before starting the measurement. Measurement: 1. Measurement conditions are as below.
Mark on Track Frame Mark on Swing Bearing T105-06-03-010 2. Operate the swing control lever fully and return it to the neutral position when the mark on upper- structure aligns with that on track frame after swinging 180 ° . 3. Measure the distance between the two marks. 4. Align the marks again, swing 180 ° , then test in the opposite direction. 5. Perform the measurement three times and cal- culate the average values. Evaluation: Refer to the Performance Standard Table in Group T4-2. Remedy: Refer to the Troubleshooting B in Group T5-7. T4-4-6 Engine Control Dial Power Mode Switch Work Mode Auto-Idle Switch Fast Idle HP Mode Digging Mode OFF