OPERATIONAL PERFORMANCE TEST / Excavator Test MAXIMUM SWINGABLE SLANT ANGLE Summary: 1. With the upperstructure swung 90 ° to the slope, check the maximum slant angle on which the upperstructure can swing to the uphill side. Preparation: 1. Check that the swing gear and bearing are well lubricated. 2. Load bucket fully. In lieu of loading the bucket, weight (W) of the following specification can be used. Backhoe: W=4650 kg (10300 lb) Loading shovel: W=6000 kg (13200 lb) 3. Position the front attachment as follows: Backhoe: With the arm cylinder fully retracted and the bucket cylinders fully extended . Loading shovel:
With the arm cylinder fully extended and the bucket cylinders fully extended. Hold the arm tip pin to the position flush with the boom foot pin height. 4. Climb a slope and swing the upperstructure 90 ° to the slope. 5. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Measurement: 1. Measurement conditions are as below. T105-06-03-011 2. Operate the swing lever to full stroke to swing the upperstructure to the uphill side. 3. If the machine can swing, measure the cab floor slant angle. 4. Increase the slope angle and repeat the meas- urement. Check both clockwise and counter- clockwise. 5. Perform the measurement three times and cal- culate the average values. Evaluation:
Refer to the Performance Standard Table in Group T4-2. Remedy: Refer to the Troubleshooting B in Group T5-7. T4-4-8 Engine Control Dial Power Mode Switch Work Mode Auto-Idle Switch Fast Idle HP Mode Digging Mode OFF