hitachi — PREPARATION FOR PERFORMANCE TESTS

OPERATIONAL PERFORMANCE TEST / Excavator Test HYDRAULIC CYLINDER CYCLE TIME 1. Summary: Check the overall operational performance of the front attachment hydraulic system (between the hydraulic pumps and each cylinder) by measur- ing the cycle time of the boom, arm, bucket, and bucket dump (open/close) cylinders with the empty bucket. 2. Bucket should be empty. Preparation: 1. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Measurement: 1. Measurement conditions are as below. T105-06-03-018 2. Position the front attachment as described in the following. Then, measure the operating time until the cylinder reaches the stroke end by fully mov- ing the control lever.

Backhoe Boom Cylinder: With the bucket cylinder fully extended and the arm cylinder fully retracted, lower the bucket to the ground. Arm Cylinder: Retract the bucket cylinder so that the arm and bucket teeth are vertical to the ground. Adjust the boom cylinder stroke so that the bucket bottom height is 0.5 m (20 in) above the ground with the bucket cylinder fully extended. Set the arm so that the center of arm operation is vertical. Bucket Cylinder: Adjust the boom and arm cylinder so that the center of full stroke movement of the bucket is positioned vertically.

0.5 m T1V1-04-05-005 T105-06-03-018 T4-4-11 Engine Control Dial Power Mode Switch Work Mode Auto-Idle Switch Fast Idle HP Mode Digging Mode OFF