Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE REPLACING ELEMENT 4 - 26 When inserting the elem ent, if the rubber at the tip is s wollen or t he outer element is not pushed i n straight, and cover (3) is ass embled by force to hook (2), there is dang damaged, so be careful 9. Install cover (3) a s follows. ) with the element. of hook (2) to the protruding part of the air and lock it in position.

1) Align cover (3 2) Hook the tip cleaner body 3) When locking on opposite si as when tight 4) When cover between the a If it is too larg of hook (2) to the protrudin and lock it in position hooks (2) in position, apply the hooks in turn des (top, bottom, left, right) in the sa me way ening bolts. (3) is installed, check that the clearance arance ir cleaner body and cover (3 ) is not to o large. e, install again. 1. Open cover on th 2. Remove 6 holder e right side of the machine. s (2), then remove cover(3). 3. Hold the outer ele ment (4), move it carefully u p and do wn and to the left and righ while pulling it out t, and rotate the element to the left a nd right .