. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the inside of air cleaner body (6). 4 - 27 4. Use a brush or cloth to remove all the dirt stuck to cover (3 ) and NOTICE The inner element must n ot be cleaned and used again. When r eplacing the ou ter element, re place the inne r element at the same time. If the inner element is not i nstalled properly and the outer element and cov er arein stalled, there i s danger that th e outer ele ment will be damaged. The seal portion on imitati on parts lacks precision, and allows th e entry o f dust, which leads to damage of the engine. D o not use such imitation parts. 5. Remove inner elemen element. Push the inner eleme securely. 6.
Push new outer elem with your hand. If you hold the elemen to the left and right, it t (5), then quickly install the new inner nt in properly and check that it is fitted ent (4) straight into the air cleaner body new inner t and move it carefully up and dow n and is easier to insert the element 7. Replace O-ring (7) for NOTICE When inserting the element, if the rubber at the tip is swollen or the outer element is not pushed in stra ight, and cover (3) is assembled by fo rce to hook (2), there is danger th at the hook and air cleaner body may be assembling. damaged, so be careful when 8. Install cover (3) as foll ows. h the element.
ook (2) to the protruding part of the air lock it in position. 1) Align cover (3) wit 2) Hook the tip of h cleaner body and 3) When locking hoo on opposite sides as when tightenin 4) When cover (3) between the air cle If it is too large, in ks (2) in position, apply the hooks i n turn (top, bottom, left, right) in the sam e way g bolts. is installed, check that the clearance clearance aner body and cover (3) is no t too l arge. stall again.