Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING 4 - 81 EVERY 2000 HOUR Maintenance for every 2 50, 500 and 1000 h ours serv ice should be carried out at t The oil is at high temperatu re immediately after the machine has been operated. Wait for the o il to cool down b efore changin g the oil. Whe n removing the oil fille r cap, turn it slowly to r elease the internal pressure, then remove O il replacement amo unt: 85 liters (22.46 U 1. Settle the machine o n the flat ground, an d lower th e blade and ripper completely wi th specified position of Rippe r and Blade, and stop the engine .

Turn the cap of oil f iller port (F) slowly to release the internal pressure, then remo ve the ca Ripper : Ripper Sha nk should be vertical to the gr ound Blade : Semi U Blad de to the ground, an d adjust. and Brace length 137 REMARK The Rear Plate of the B lade is almost vertica l to the Ground. 2. Remove plug (1) at the bottom of the h ydraulic tank, loosen drain valve (2), and drain the oil. After dr aining th e oil, tighten drainvalve (2) and p lug (1). When loosen ing drain valve (2), be careful not to get oil over yourself.