. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE details, see "CHECK OIL LEVEL IN 4 - 82 3. Loosen 6 bolts, then remove cover (3). When do ing this, the cover may fly out und the cover down when rem 4. After removing spring element (7). Inspect the bottom any. Take good ca hydraulic tank. After removing spring element (7). Inspect the bottom of the filter case for dirt, and remove it, if re then not to let fall the dirt into the rts in flushing oil. the 5. Clean the removed pa 6. Install the new elemen t in the place where old ele ment (7) was installed. 7. Set valve (5), strainer (6) and spring (4) on top of the element. 8.
Set cover (3) in positio n, push it down by hand, a nd install the cover with the mounin 9. Screw in the oil filler c 10. To bleed the air, star "STARTING ENGINE (PAGE 3-11 minutes. Stop the engine. After filling with oil, c 8)" and run the engine at lo w idle fo r 10 11. 12. HYDRAULIC TANK, ADD OIL (PAGE 3-105)". level. CLEAN ENGINE BREATHE R ELEMENT m around the breather (1). 1. Wipe off all the dirt fro 2. Remove breather (1). 3. Rinse the breather uni t in diesel oil or flushing oil, then dry with compressed air. 4. Replace the breather O-ring with a new part, coa t with engine oil, then install.
CHECK ALTERNATOR, ST ARTING MOTOR The brushes may be worn or the bearing may have run out of greas e, contact your Komatsu distributor for inspection and repairs. quently, have this inspection carried out every 1000 hours. f th e engine is started fre quently, have this inspectio n carried out every