Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE seen at the top. 4 - 84 3) Lower co ver (2) gradually t o open it. Drain plug ( P) can be Remove dip oil. After drainin 4. Add oil throu gh the holder of d ipstick (G ). After adding the oil, insert dipstic 5. Remove any dirt or dus t stuck to breath er (5), then wash with clean diese l oil or fl ushing oil. If it w part. leaned completely, replace wit h a ne 6. Install under cover (2), t hen clo se engin e side c over (1) on the left side of th e machine CHECK PIVOT BEARING OIL LEVEL, ADD O Specified cap acity 11 l 1. Remove plu g (1). he oil level is up to the oil level (25 mm (1.0 in)) e diagram.

If the oil level is low, add engine oil hole of plug (1). 1). 2. Check that t shown in th e diagram. through the hole of plug 3. Install plug ( 1.0 in)) engine