Cylinder Head and Valves Replace Valve Guides Remove Valve Guides 1. Position cylinder head with combustion face facing up. 2. Drive valve guides from combustion face side of cylinder head using JDG164A Driver (A) and a press. RG8823 –UN–11DEC97 3. Inspect valve guide bore for cracking or excessive metal transfer. Thoroughly clean valve guide bore. 4. Measure valve guide bore in cylinder head. Replace cylinder head if valve guide bore is not within specification. Removing Valve Guide with JDG164A A—JDG164A Valve Seat Pilot Driver Specification Valve Guide Bore in Head—ID 14.94 ± 0.02 mm (0.5882 ± 0.0008 in.) ......................
CTM100 (06APR04) 02-020-33 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,85 –19–16OCT00–1/2 040604 PN=105 Measure Valve Guide ID 1. Measure valve guides ID using a telescopic gauge. 2. Record measurements and compare readings with valve stem OD to determine stem-to-guide clearance. –UN–21MAY98 Specification Valve Guide—ID........................................... 9.045 ± 0.013 mm (0.3583 ± 0.0005 in.) Valve Stem—OD.......................................... 8.999 ± 0.013 mm (0.3543 ± RG8308 0.0005 in.) Valve Stem-to-Guide—Clearance.................................
0.077—0.129 mm (0.0030—0.0050 in.) Measuring Valve Guide ID Replacement valve guides are available if valve guide ID is not within specification for specified guide-to-stem clearance (See REPLACE VALVE GUIDES, later in this group). RG,RG34710,84 –19–01NOV00–1/1 02 020 33