Delphi — Clean and Inspect Valve Seats

Cylinder Head and Valves Install Valve Guides 1. Assemble JDG1167 Valve Guide Installation Adapter (A) and JDG164A Driver (B) onto replacement valve guide (C). 02 020 34 2. Position cylinder head resting on combustion face. RG8824 –UN–11DEC97 3. Position valve guide over bore in cylinder head and press guide in head until adapter bottoms on machined surface. 4. Measure valve guide installed height. Installed height should be as follows: Installing Valve Guide A—JDG1167 Valve Guide Installation Adapter B—JDG164A Valve Seat Pilot Driver C—Replacement Valve Guide Specification Valve Guide—Installed Height 14.5—15.5 mm (0.57—0.61 in.) ................ 5.

Insert a valve stem through valve guide to check for adequate clearance. Valve stem should move freely in valve guide. RG,RG34710,85 –19–16OCT00–2/2 Clean and Inspect Valve Seats 1. Use an electric hand drill with copper or brass (soft) wire brush to remove all carbon on valve seats. 2. Inspect seats for excessive wear, cracks, or damage. 3. Check entire combustion face for rust, scoring, pitting, or cracks. RG,RG34710,86 –19–30SEP97–1/1 CTM100 (06APR04) 02-020-34 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=106