Delphi — Grind Valve Seats

Cylinder Head and Valves CTM100 (06APR04) 02-020-35 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=107 Grind Valve Seats IMPORTANT: Valve seat grinding should only be done by experienced personnel familiar with equipment and capable of maintaining required specifications. ALWAYS keep valve guides and work –UN–06DEC97 area clean when grinding valve seats to maintain valve guide bore-to-seat runout. RG8311 Grinding valve seats increases seat width and valve recess in cylinder head. Valve Seat Grinding Pilot DO NOT grind excessively. Only a few seconds are required to recondition the average valve seat. Dress grinding stone as necessary to maintain specified seat angle.

Support the weight of grinder to avoid –UN–06DEC97 excessive pressure on the stone. Blend or radius all sharp edges 0.50 mm (0.02 in.) maximum corner RG8312 break to eliminate burrs after grinding valve seats. Valve Seat Arbor and Grinding Stone 1. Install appropriate pilot (A) in valve guide bore. 2. Install appropriate grinding stone (B) on arbor (C) and position onto valve seat and pilot. 3. Using drill from JT05893 Heavy-Duty Seat Grinder Set, grind valve seats to the following specifications: –UN–21MAY98 Specification Valve Seat Grinding—Contact Angle.....................................................................................................

30° RG8313 Width................................................... 1.50—2.00 mm (0.059—0.079 in.) Maximum Runout....................................................... 0.16 mm (0.006 in.) Grinding Valve Seat A—Pilot B—Grinding Stone C—Arbor Continued on next page RG,RG34710,87 –19–28NOV00–1/2 02 020 35