Delphi — Remove Valve Seat Inserts

Cylinder Head and Valves 4. Use a vernier caliper or scale to measure seat width. If valve seat is too wide, reduce the width with a narrowing stone. 02 020 NOTE: A narrowing stone will change the top angle of the seat and reduce the outer diameter of the valve seating area. Varying the width changes the fine contact between valve face and seat. If seat width is too narrow, valve may burn or erode. 36 RG6318 –UN–03NOV97 5. If valve does not seat properly, use an eccentrimeter (A) to check valve seat runout. Use a new or refaced valve and blueing to check contact between valve seat and face. If necessary, lap the valve onto its seat using a lapping tool and lapping compound.

Replace valves and inserts as necessary. Measuring Valve Seat Runout A—Eccentrimeter 6. Install new or refaced valve and check valve recess in cylinder head after grinding. (See CHECK VALVE HEIGHT IN RELATION TO HEAD SURFACE earlier in this group.) RG,RG34710,87 –19–28NOV00–2/2 Remove Valve Seat Inserts IMPORTANT: Be careful not to damage cylinder head when removing valve seats. Use JDE41296 Valve Seat Puller (A). Adjusting screw (B) may need to be retightened during removal of inserts. RG8314 –UN–06DEC97 After removal of inserts, thoroughly clean area around valve seat bore and inspect for damage or cracks. Measure bore ID.

(See MEASURE VALVE SEAT BORE IN CYLINDER HEAD in this group.) A—JDE41296 Valve Seat Puller B—Adjusting Screw Removing Valve Seat Insert RG,RG34710,88 –19–30SEP97–1/1 CTM100 (06APR04) 02-020-36 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=108