Cylinder Head and Valves Measure Cylinder Liner Standout (Height Above Block) 1. Secure liners using cap screws and flat washers. Flat washers should be at least 3.18 mm (1/8 in.) thick. Tighten cap screws to 68 (50 lb-ft). 02 020 56 2. Using JDG451 or KJD10123 Height Gauge (B) and D17526CI or D17527CI Dial Indicator (C), measure liner height (A) at approximately 1, 5, 7, and 11 o’clock positions as viewed from flywheel end of engine. Record all measurements by cylinder number. RG6439 –UN–03NOV97 Liner Standout Specification Cylinder Liner—Height Above Block (Standout) 0.030—0.117 mm (0.0012—0.0046 in.) ............................................................ Cylinder Liner—Max.
Height Difference at Nearest Point of Two Adjacent Liners or Within One Liner 0.051 mm (0.0020 in.) ................................................................ RG8329A –UN–06DEC97 IMPORTANT: ONE LINER SHIM ONLY may be installed under any given liner flange. 3. Remove liner, add shims or replace any liner that does not fall within allowable standout specification. Measuring Liner Standout Two sizes of shims are available: A—Liner Height B—Height Gauge C—Dial Indicator R81276 ................................................................... 0.05 mm (0.002 in.) R87277 ...................................................................
0.10 mm (0.004 in.) RG,RG34710,94 –19–30SEP97–1/1 CTM100 (06APR04) 02-020-56 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=128