Delphi — Install Cylinder Head

Cylinder Head and Valves CTM100 (06APR04) 02-020-57 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=129 Install Cylinder Head IMPORTANT: Be sure cylinder head and block gasket surfaces are clean, dry, and free of any oily residue. ALWAYS thoroughly inspect new cylinder head gasket for possible manufacturing imperfections. –UN–05DEC97 Return any gasket that does not pass inspection. 1. Place a new head gasket on top of cylinder block. Do RG8189 not use sealant on gasket. Tab (A) on gasket goes to left rear corner of cylinder block (as viewed from Installing Cylinder Head Gasket flywheel end). IMPORTANT:

If cylinder head is lowered onto cylinder block and you discover that the head is not positioned correctly on locating dowels, remove cylinder head and install a new gasket. DO NOT try to –UN–21MAY98 reposition cylinder head on the same gasket again since the fire ring will possibly be damaged. RG8285 2. Lower cylinder head in correct position on block using lifting straps and a hoist. Make sure that head is Installing Cylinder Head positioned correctly over dowels and that it is all the way down on gasket. A—Tab Continued on next page RG,RG34710,95 –19–27NOV00–1/2 02 020 57