Cylinder Head and Valves 02 020 58 RG8347 –UN–19MAY98 Cylinder Head Cap Screw Torque Sequence IMPORTANT: Whenever cylinder head is removed for service, all cap screws MUST BE replaced when head is installed. These cap screws can only be used one time. This prevents head from tipping during tightening sequence. 5. Use torque-turn method to tighten all cylinder head cap screws to specifications. (See TORQUE-TURN CYLINDER HEAD CAP SCREWS next in this Group.) NOTE: All 26 cylinder head cap screws are the same length. 3. Dip new cap screws and washers in clean SAE 30 engine oil. Allow excess to drain off threads. 4. Initially tighten No. 17 cap screw to specifications.
Specification Step 1—Cylinder Head No. 17 Cap Screw—Initial Torque 100 (74 lb-ft) ...................................... RG,RG34710,95 –19–27NOV00–2/2 CTM100 (06APR04) 02-020-58 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=130