CTM100 (06APR04) 02-020-59 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=131 Cylinder Head and Valves Torque-Turn Cylinder Head Cap Screws Arrow (A) points toward front of engine. IMPORTANT: DO NOT use multi-viscosity oils to lubricate cap screws. 1. Lubricate cap screws with clean SAE 30 engine oil and install in their proper locations as outlined previously. 2. If not done, initially tighten cap screw No. 17 to specification to prevent head from tipping during tightening sequence. Specification Step 1—Cylinder Head No. 17 Cap Screw—Initial Torque............................................ 100 N•m (74 lb-ft) Following figure on previous page, sequentially start at cap screw No.
1 and proceed through cap screw No. 26 and tighten all cap screws to 163 N•m (120 lb-ft). Specification Step 2—All Cap Screws (Nos. 1—26)—Initial Torque................................................. 163 N•m (120 lb-ft) 3. Wait 5 minutes and verify above torque. Specification Step 3—Verify All Cap Screws (Nos. 1—26)—Torque................................................. 163 N•m (120 lb-ft) 4. Using an oil-proof pen, pencil, or marker, draw a line parallel to the crankshaft across the entire top of each cap screw head. This line will be used as a reference mark. –UN–09DEC97 IMPORTANT:
If a cap screw is accidentally tightened more than 90° in first sequence, DO NOT loosen cap screw but make adjustments in the next tightening RG8346 sequence. Torque-Turn Cylinder Head Cap Screws 5. Sequentially (start at cap screw No. 1 and proceed A—Front of Engine through cap screw No. 26) turn each cap screw 90°. Line on top of cap screw will be perpendicular to crankshaft. Continued on next page RG,RG34710,96 –19–28NOV00–1/2 02 020 59