Delphi — Torque-Turn Cylinder Head Cap Screws

Cylinder Head and Valves Specification Step 4—All Cap Screws (Nos. 1—26)—Initial Torque-Turn 90 ° ................................................................... IMPORTANT: Cap screws MUST NOT be tightened more than a total of 180 ° —190 ° . 02 020 60 6. Finally, sequentially (start at cap screw No. 1 and proceed through cap screw No. 26) turn each cap screw an additional 90 ° , SO THAT LINE ON TOP OF CAP SCREW IS AS CLOSE AS POSSIBLE TO BEING PARALLEL TO THE CRANKSHAFT. It is not necessary to obtain the final turn in one swing of the wrench. TOTAL AMOUNT OF TURN FROM STEPS 5, and 6, is 180 ° —190 ° . Specification Step5—All Cap Screws (Nos.

26)—Final Torque-Turn 90 ° ......................................................................... Cylinder head torque procedure summarized as follows: Cylinder Head—Specification Step 1—No. 17 Cap Screw— Initial Torque 100 (74 lb-ft) .................................................................. Step 2—All Cap Screws (Nos. 1—26)—Initial Torque 163 (120 lb-ft) ................................................. Step 3—Wait 5 Minutes and Verify All Cap Screws (Nos. 26)—Torque 163 (120 lb-ft) ................................................................. Step 4—All Cap Screws (Nos. 1—26)—Initial Torque-Turn 90 ° ...................................................................

Step 5—All Cap Screws (Nos. 1—26) 1 —Final Torque-Turn 90 ° .................................................................. 1 Total torque-turn for steps 4 and 5 is 180 ° . RG,RG34710,96 –19–28NOV00–2/2 CTM100 (06APR04) 02-020-60 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=132