Cylinder Head and Valves IMPORTANT: DO NOT reuse rocker arm shaft hold-down clamp cap screws. Ensure that new cap screws are used for reassembly. 02 020 NOTE: On early engines with dual rail fuel system, install hold-down clamps (A) with oil tube (B) at second clamp location from front and rear of engine. 62 RG8262A –UN–06DEC97 5. Install rocker arm hold-down clamps. Install cap screws finger tight. 6. Install twelve valve bridges (D) with slots (E) facing exhaust manifold side of engine. Be sure each bridge is properly seated onto two respective intake and exhaust valves within a given cylinder. Rocker Arm Oil Tube 7. Install twelve push tubes (C) on top of bridges. 8.
Make sure intake, exhaust, and injector rocker arm adjusting screws are loose to eliminate binding shaft as clamps are tightened. RG10343 –UN–09SEP99 9. Initially tighten rocker arm hold-down cap screws in the end of each shaft to pull shaft down onto locking roll pins. Next, going from front-to-rear of engine, tighten hold-down clamp cap screws to the following specification: Valve Bridges and Push Tubes A—Hold-Down Clamps B—Oil Tube (Early Engines with Dual Rail Fuel System) C—Push Tubes D—Valve Bridges E—Slots Specification Rocker Arm Shaft Hold-Down Clamp Cap Screws (All Engines)—Initial Torque 30 (22 lb-ft) ..................................................
Make an additional pass from front-to-rear and verify torque specification above. IMPORTANT: Torque-Turn procedures for rocker arm shaft clamp cap screws differ between engines with dual rail and single rail fuel systems. Use proper procedure for engine application. 10. Torque-Turn rocker arm shaft clamp cap screws using proper procedure for type of fuel system as detailed on following pages. CTM100 (06APR04) 02-020-62 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,97 –19–01NOV00–3/9 040604 PN=134